Komatsu PC22MR-3, Operation & Maintenance Manual

Page: 186 / 312

TRANSPORTATION
FUNCTIONING
3-98
4. When loading, set the work equipment at the front and the
blade at the back, with the undercarriage and the turret
parallel.
5. Before getting on the ramps, make sure that the machine is
in line with the ramps and that the centerline of the
machine corresponds to the centerline of the trailer.
The machine must move slowly and its travelling direction
must correspond to the direction of the ramps.
Lower the work equipment as much as possible, without
causing any interference.
When the machine is on the ramps, operate only the travel
levers. Do not operate any other lever.
6. Stop the machine where requested, then slowly rotate the
turret of 180°.
Securing the machine on the means of transport
After positioning the machine on the trailer, it is necessary to secure it by proceeding as indicated below.
NOTICE
To avoid damaging the bucket cylinder during transport,
position a wooden block at one end of the cylinder to
prevent it from touching the ground.
1. Lower the blade.
2. Fully extend the bucket cylinder of the 2nd boom and lower
the 1st boom slowly.
3. Stop the engine and remove the ignition key.
WEAM014500