Komatsu Galeo PC27MR-2, Operation & Maintence Manual

Page: 149 / 261

.
OPERATION
TRANSPORTATION
LIFTING MACHINE
WARNING
Never raise the machine with any worker on it.
Always make sure that the wire rope used for lifting the machine is of ample strength for the weight of the machine.
Never lift the machine with the upper structure swung to the side. Swing the work equipment so that it is at the sprocket end
and set the undercarriage and upper structure parallel before lifting.
When lifting, keep the machine horizontal.
Never go under the machine when it is raised.
Never try to lift the machine in any posture other than the posture given in the procedure below.
There is a hazard that the machine may lose its balance.
CAUTION
It is prohibited to use the 4 hooks on the top of the cab to lift the
machine. This will damage the cab.
It is prohibited to use the transportation holes in the track frame to lift
the machine. This will damage the track frame.
NOTICE
For the details on the machine weight, see the section of
"SPECIFICATIONS (PAGE 5-2)".
The lifting procedure applies to machines with standard specifications.
The method of lifting differs according to the attachments and options
actually installed. In such cases, please contact your Komatsu
distributor for information.
When lifting the machine, carry out the operation on flat ground as follows.
1. Start the engine, then swing the upper structure so that the
work equipment is at sprocket (1) end with the track frame and
upper structure set parallel.
2. Raise the blade fully.
3. Extend the bucket cylinder, arm cylinder, and boom cylinder
fully.
4. When the boom swing has been operated to the left or right,
operate the boom swing control pedal to set the boom parallel
to the track frame, then set the swing lock cover to the LOCK
position.
3 - 97