Komatsu Galeo HD325-6, Operation & Maintenance Manual

Page: 311 / 317

.
ATTACHMENTS, OPTIONS
ASR-II (AUTOMATIC SPIN REGULATOR II)
Remedy pattern 2
When only the ASR caution lamp flashes
The ASR system continues to be actuated, but an abnormality has occurred in the system.
Stop at the safe place quickly and turn the system switch OFF to stop use of the ASR.
When the system switch is turned OFF, the ASR caution lamp will go out.
In the case of patterns 1 and 2 above, turn the system switch OFF quickly, stop use of the ASR and contact your
Komatsu distributor for repairs.
WHEN SYSTEM IS NORMAL
The code (0.0) is displayed by the controller LED behind the assistant's seat.
METHOD OF DISPLAYING MODEL SELECTION, TIRE LARGE DIAMETER/SMALL DIAMETER, FAILURE CODE
When the starting switch is turned ON, the codes below are automatically displayed in the following order on the
controller LED.
1. LEDs all light up.
2. Model
Code: 32
3. Tire diameter
Code: --
4. Latest failure code
5. Failure code that occurred immediately before the failure code in 4.
6. Failure code that occurred immediately before the failure code in 5.
METHOD OF CLEARING FAILURE CODE
When the starting switch is at ON position (when the engine is not started), disconnect the connectors CR1 and CR2
located behind the operator's seat. At this time, "
– –
" is displayed on controller LED. When the flashing of "
– –
"
turns to the lighting up of "
– –
" (3 seconds), then failure code is cleared.
REMARK
When the ASR is used at the first time, be sure to clear the failure code. Connect the connectors CR1 and CR2 after
the clearance.
6 - 48