Manual EDU 2AE/TOP e EDU 2AE/TOP/TA Rev.1.1
Page 9
- - - S E Q U E N C E - M E N U - - - -
3 ) E x t
b o x :
O F F
4 ) M o d .
b a r c :
O F F
5 ) R e s .
a u t
s e q :
O F F
3) Ext box:
It allows to enable or disable the external switch box. ON = switch box enabled; OFF = switch
box disabled.
4) Barc. mode:
–
Barcode mode
: It allows to choose the barcode mode.
OFF:
barcode disabled.
ON prog:
you can select the program to be executed by scanning the bar code of the product. The
unit compares the scanned code to the one previously entered in each program (see point 25: Barc.
Set.). If the two codes are the same as the program is loaded, otherwise it will appear Error
Barcode. The scanned product code is also printed on the serial port of the control unit (see
paragraph “
serial print
”)
.
ON S.N.:
the product code is required before carrying out a cycle or a sequence. The product code
is printed on the serial port of the control unit.
5) Aut. res seq:
If ON, the control unit automatically resets after the end of the sequence. If OFF it is
necessary to press OK at the end of each sequence.
OPTION MENU:
- - - - O P T I O N - - M E N U - - - -
O K
c h a n g e
E S C
q u i t
1 ) L a n g u a g e :
I T
2 ) C h a n g e
p a s s w o r d
1) Language:
This option allows to choose among 6 languages: English, Italian, German, Spanish, French
and Portuguese.
2) Change password:
You can change password (see point 3).
- - - - O P T I O N - - M E N U - - - -
3 ) P a s s w o r d :
O N
4 ) E S C - O K :
I N T + E X T
5 ) R e s e t :
P R G
3) Pass ON:
If YES, you will be asked for the password to enter the menu. Otherwise select NO.
ATTENTION: Password is only asked to enter the menu the first time after switching the unit on.
The default password is: 0000.
4) ESC-OK:
Press ESC in case of error. Press OK at cycle end or to reset a cycle or a program (see point
5: Reset). If INT,
the operator must press the required key on the front panel. If it’s set on EXT, the keys on
the front panel are disabled and functions can only be enabled through proper connections on the back panel
(
see paragraph “I/O connections”).
