Vers. 100822 Page 10
- - - - - M E N U - - P R : 1 - - - - -
3 1 ) A n g . m i n : - - - -
3 2 ) A n g . m a x : - - - -
32) Ang. max - Maximum angle:
Maximum angle threshold. You can set it when T&A is set on Tor, T/in
or T/lv (see T&A specific instructions). The maximum angle the operator can set is 29999°.
When T&A is set on Ang., A/in or A/lv mode, maximum angle corresponds to the angle that has to be carried
out.
SEQUENCE MENU:
- - - S E Q U E N C E - M E N U - - - -
O K c h a n g e E S C q u i t
1 ) S e q s e t : 1 4 7 3 9 8 1 2
2 ) S e q u e n c e : o f f
1) Seq set:
you can set a sequence up to max. 8 programs.
To set the next program in the sequence, press OK.
Press to save the sequence and quit.
To set the programs of a sequence, it is suggested to set the
Model Detect in Manual
and manually select the
desired screwdriver model for each program. Then enable automatic recognition. If you select a program
which does not have a screwdriver model set (----), the
Select model
warning will appear and this setting will
be exited.
2) Sequence:
to enable or disable the sequence. ON = enabled; OFF = disabled.
- - - S E Q U E N C E - M E N U - - - -
3 ) E x t b o x : o f f
4 ) M o d . b a r c : o f f
5 ) I n s . b a r c o d e S e q
3) Ext box:
It allows to enable or disable the external control.
IMPORTANT
: It is
mandatory
to select ON to work with switch box, socket tray and remote.
4) Barc. mode: – Barcode mode
: It allows to choose the barcode mode.
•
OFF:
barcode disabled.
•
ON prog:
you can select the program to be executed by scanning the bar code of the product. The
unit compares the scanned code to the one previously entered in each program (see point 27: Barc.
Set.). If the two codes match, the program is loaded; otherwise it will display
Error Barcode
. The
scanned product code is also printed on the serial port of the control unit (see paragraph “
serial print
”).
•
ON S.N.:
the product code is required before running a program or a sequence. The product code is
printed on the serial port of the control unit.
•
ON Seq.
: you can set the Sequence by scanning its barcode. The code scanned is compared with the
sequence entered in the menu (see point 5: Ins. Barcode Seq on Menu Sequence). If the two codes
match, the sequence set is loaded, otherwise display “
Repeat scan
”. The read code is also printed on
the serial port of the control unit (see section Serial Print).
