Koike Sanso Kogyo AUTO PICLE-S, Manual

Page: 26 / 54

AUTO PICLE-S
25
5.1 Safety measures prior to operation
Strictly observe the safety rules, precautions and instructions to ensure
safety during gas cutting operations. Operators and supervisors MUST
keep safety in mind.
5.1.1 Grounding the machine
The cable of this machine is
equipped with a grounding wire. For
safety, be sure to ground the wire as
follows (see figure 5 - 1):
• Connect the clip to the steel
frame as shown in the diagram. If
a grounding wire is already
provided at the site, connect the
clip to the wire.
5.1.2 Selection of tip
Referring to the Cutting Data, select the suitable tip according to the plate
thickness.
For a heavily rusted plate or a bevel cutting angle of more than 20°, select
the tip one grade higher than the one shown in the Cutting Data.
5.1.3 Operation of running direction changeover switch
Danger
Be sure to check that the power switch is in the stop position before
turning on the power. If the power switch is on, it is dangerous to
start the machine.
Never put your hand between the machine and the rail when the
machine is running; otherwise your hand may be caught between
them.
1. Steel frame
2. Wiring pipe
3. Switch box
4. Rubber plug
5. Cabtyre cord
6. To the machine body
7. Ground wire
8. Clip
9. Concrete foundation
3
1
2
4
5
6
9
7
8
figure 5 - 1
Auto Picle-S.book Page 25 Thursday, April 11, 2002 11:15 AM