- 2 -
KD 477-2 Workshop Manual_cod. ED0053029370_
1° ed
_ rev.
00
CUSE/ATLO
REGISTRATION OF MODIFICATIONS TO THE DOCUMENT
Any modifications to this document must be registered by the drafting body, by completing the following table.
PREFACE
- Every attempt has been made to present within this service manual, accurate and up to date technical information.
However, development on the
KOHLER
series is continuous.
Therefore, the information within this manual is subject to change without notice and without obligation.
The materials used by
KOHLER
to construct the engine's components undergo strict quality controls and the engine's
assembly guarantees reliability and long life.
The engine has been built to the machine manufacturer's specifications, and it was its responsibility to adopt all the measures
needed to meet the essential health and safety requirements as provided for by the laws in force; use of the engine for uses
other than the one defined shall not be considered as compliant with the use intended by
KOHLER
, who therefore refuses all
responsibility for any injury arising from such an operation.
- The information contained within this service manual is the sole property of
KOHLER
.
As such, no reproduction or replication in whole or part is allowed without the express written permission of
KOHLER
.
Information presented within this manual assumes the following:
1 - The person or people performing service work on
KOHLER
series engines is properly trained and equipped to safely and
professionally perform the subject operation;
2 - The person or people performing service work on
KOHLER
series engines possesses adequate hand and
KOHLER
special
tools to safely and professionally perform the subject service operation;
3 - The person or people performing service work on
KOHLER
series engines has read the pertinent information regarding the
subject service operations and fully understands the operation at hand.
-
This manual was written by the manufacturer to provide technical and operating information to authorised
KOHLER
after-sales
service centres to carry out assembly, disassembly, overhauling, replacement and tuning operations.
-
As well as employing good operating techniques and observing the right timing for operations, operators must read the
information very carefully and comply with it scrupulously.
-
Time spent reading this information will help to prevent health and safety risks and financial damage.
Written information is accompanied by illustrations in order to facilitate your understanding of every step of the operating phases.
KD 477-2
Drafting
body
Document
code
Edition
Issue date
Review
date
Model
N°
Revision
Endorsed
1°
0
05/07/2012
05/07/2012
ED0053029370
51265
