Tools and Materials
Before You Begin
CAUTION: Risk of personal injury.
To eliminate the risk of
scalding, the water temperature should never be set above
120°F (49°C).
DANGER: Risk of scalding or other severe injury.
Before
completing installation, the installer must set the maximum
water temperature setting of this valve to minimize the risks
associated with scalding hazards according to ASTM F 444.
CAUTION: Risk of scalding.
This device has been calibrated
at the factory to ensure a safe maximum water temperature.
Any variance in settings or water inlet conditions from those
used during factory calibration may raise the discharge
temperature above the safe limit, and may present a scalding
hazard. Responsibility for installation and adjustment of this
device in accordance with these instructions lies with the
installer.
IMPORTANT!
No minimum wall thickness is required if the wall
material is strong enough to support the trim. If the walls are less
than 1/2
″
(1.3 cm) thick, it is recommended reinforcement be added
to prevent the wall from flexing when the trim is tightened. Flex in
the wall will result in improper front plate installation.
Observe all local plumbing and building codes.
Mounting Nut
Installation Tool
(Supplied with Valve)
Temporary
Shut-Off
Knob
(Supplied with Valve)
Adhesive Caulk
or Sealant
1066047-2-C
2
Kohler Co.