6. Complete the Wall-Mount Installation
CAUTION: Risk of personal injury or product damage.
Avoid excess stress on the mounting
brackets and wall. Do not allow the mounting brackets to support the entire weight of the sink at
any time. Make sure the front of the sink is always supported.
Make sure the sink is level.
Place a bead of epoxy on the finished floor beneath each of the leveling feet.
Turn the leveling feet until each foot rests on the floor.
Remove the temporary frame or braces.
NOTE:
If installing the optional sink shelf K-21107, ensure that the faucet supply lines are routed and
installed above the shelf.
NOTE:
If installing the optional sink shelf K-21107, ensure that the bottom of the P-trap sits no more than
10-1/2
″
(267 mm) below the bottom of the sink.
Connect the faucet.
Install the drain.
Install the optional towel bar.
Apply a bead of 100% silicone sealant where the sink meets the wall.
Towel Bar
(Optional)
Epoxy
1330810-2-A
8
Kohler Co.
