5
116897-2-
AB
Kohler Co., Kohler, WI
F. INSTALL DOOR ENCLOSURE
NOTE: Wear Safety Glasses.
The following steps explain installing wall jambs using
hollow wall anchors.
Align door assembly to receptor and place onto the
shower floor ledge with the bottom track 3/16” from the
edge of the shower floor ledge.
Adjust the expander jambs by turning the two adjustment
screws on each side. Turning the screws counterclock-
wise will increase the width of the assembly; turning the
screws clockwise decreases the width of the assembly.
Adjust each expander jamb until both wall jambs touch the
wall at the bottom. Adjust top until jambs touch the wall.
Adjustment Screw
After adjusting, mark the three hole locations through the
locator holes in each wall jamb and expander jamb.
Move the door assembly to one side and lightly center
punch the three hole locations on the wall. On ceramic tile,
use a center punch to nick the surface glaze. Tap the
punch lightly with a hammer so as not to crack the tile.
Drill three holes into each wall with a 5/16” drill bit. Use a
5/16” masonry bit for ceramic tile.
After drilling all six holes, thoroughly clean the shower
floor ledge and wall. Insert the hollow wall anchors into all
six 5/16” drilled holes.
Install the door assembly into opening and align the
locator holes with the holes in the wall. Make minor
adjustments using the adjustment screws, as necessary.
Secure sides of enclosure at bottom by installing two
#8-18 x 1-1/4” panhead screws through each expander
jamb and wall jamb into the installed anchors in wall.
Repeat, securing the top of the enclosure and lastly the
middle.
