11.22
Section 11
Reassembly
Figure 11-74. Wiring and Harness in Clamp on #1
Side.
Install Spark Plugs
1. Use new Champion
®
RC14YC (Kohler Part No.
66 132 01-S) or equivalent spark plugs.
2. Set the spark plug gap to 0.76 mm (0.030 in.).
3. Install the plugs and torque to 24.4-29.8 N·m
(18-22 ft. lb.). See Figure 11-75.
Figure 11-75. Installing Spark Plug.
Install Starter Assembly
1. Mount the starter to the adapter plate using the
two hex. flange screws.
NOTE:
The stator leads and rectifier-regulator
plug must be above the starter.
2. Make sure the starter is square to the flywheel,
and torque the two hex. flange screws to 15.3 N·m
(135 in. lb.). See Figure 11-76.
Figure 11-76. Torquing Starter Bolts.
3. Attach the leads to the appropriate starter solenoid
terminals. See Figure 11-77.
Figure 11-77. Connecting Starter Leads to Starter.
4. To avoid damage or breakage, do not over-
tighten the hex. flange nut when attaching the
positive battery cable. Torque the nut to 6-9 N·m
(53-79 in. lb.).
Not For Resale
www.SmallEngineDiscount.com
