11.7
Section 11
Reassembly
11
Figure 11-16. Closure Plate Sealant Pattern.
4. Make sure end of governor cross shaft is lying
against the bottom of cylinder #1 inside of the
crankcase. See Figure 11-17
5. If alignment pins were removed previously, install
them in their respective locations in the crankcase.
See Figure 11-17.
Figure 11-18. Rotating Crankshaft to Seat Closure
Plate.
7. Install the ten hex. flange screws securing the
closure plate to the crankcase. If a thick flat
washer was used on one of the screws, install
it in the #10 location. Install the silver plated
(ground) screw in its original location (normally
the #4 or #6 location). Torque the fasteners, in the
torque sequence shown in Figure 11-19 to
24.4 N·m (216 in. lb.).
Figure 11-17. Installing Locating Pins.
6. Install the closure plate on the crankcase.
Carefully seat the camshaft and crankshaft into
their mating bearings. Rotate the crankshaft to
help engage the oil pump and governor gear
meshes. See Figure 11-18.
5
3
1
2
4
6
7
8
9
10
Plated
Screw
Location
Figure 11-19. Closure Plate Torque Sequence.
Not For Resale
www.SmallEngineDiscount.com
