2. Packaged Product Check
At time of product delivery, always check for missing items before starting use.
If the product is damaged or operates incorrectly, contact the distributor where
the product was purchased, or the nearest Koganei representative office or
overseas department.
Main body (DTY-CMH-01)
1pc.
AC adaptor (DTY-CMA-PS01)
1pc.
Owner’s Manual (this book)
1
Ferrite core (ZCAT2032-0930: Made by TDK)
1pc.
3. Product Overview
The CC monitor DTY-CMH-01 is a device that uses the light scattering principle
to simply detect and display the cleanliness level. In addition, it can use
Ethernet communication to collect data on a personal computer. Output
characteristics are comparison data calibrated with a JIS standard particle
counter.
●
Displays the cleanliness level in 10 stages on LEDs (equivalent to ISO
classes 5 to 8).
●
When the alarm value is set to a desired level, and cleanliness exceeds that
level, 3 types of alarms are turned on, including a buzzer, LED indicator, and
alarm output (open collector output).
●
Ethernet signal output based on a TCP/IP network protocol can be used to
collect data on a personal computer.
●
Uses an ingenious heater air intake method that eliminates the need for
pumps or tubes, for simple detection merely by installation at the location
where cleanliness conditions are to be checked.
@7
4. Major Parts and Function
No.
q
w
e
r
t
y
u
Front of the body
Bottom of the body
Right side of the body
w
q
q
r
e
t
y
u
u
@8
Parts
Ventilation inlet
and outlet
Level display
LAN terminal
Power supply jack
Reset switch
Rotary switch
Mounting hole 1
(For M4 screw)
Functions
Air entering from the bottom ventilation inlet passes across an
internal sensor and then exits from a ventilation outlet on the top.
Be careful to avoid blocking the ventilation inlet and outlet.
LEDs light up to show the cleanliness level. For details,
see the explanation of the body display area on p.
#0
.
Ethernet (RJ-45) communication connector. LAN cable can
be used to connect to a network hub or a personal
computer, to collect data.
Connects to a dedicated AC adaptor.
Switch for restoring body operations to the initial state (the
state immediately after the power was switched on.)
Switch (dial) for setting the point to output the alarm. Use a
Phillips screwdriver to rotate and set.
Can be used when mounting from the front.
