●
Do not pull out the connectors while the power is on. In addition, do not apply
unnecessary stress on the connector. It could result in erroneous equipment
operation that could lead to personal injury, equipment breakdown, or electrical
shock, etc.
●
Always check the Owner’s Manual and other reference materials for product
wiring. Incorrect wiring will result in abnormal operation.
●
Because there is a risk of a break in the AC adaptor cable, do not use with
movable parts.
CAUTION
●
Avoid placement, use, or storage in any of the following locations or
environments.
・
Locations where the ambient temperature exceeds the range of 0 to
＋
40˚C
[32 to 104˚F] .
・
Locations where the ambient humidity is 90% or higher.
・
Locations with sudden temperature changes that lead to condensation.
・
Locations subject to corrosive gases or flammable gases.
・
Locations where vibrations or shocks can be transmitted directly to the main
・
body.
・
Locations subject to water, oil, chemicals, or steam.
・
Locations with large quantities of dust, salts, or metal powder, etc.
・
Locations with inductive interference, or where static electricity, magnetism, or
noise commonly occur.
・
Locations directly in the path of air blowing from air conditioners.
・
Locations subject to direct sunlight.
・
Locations where radiant heat, etc., results in heat accumulation.
●
Do not wipe the device with benzene, thinner, or a wet cloth, etc.
●
This product is a Class 1 laser product regulated under JIS C 6802 (2005).
While a laser is used for the internal particle judgment mechanism, the laser
light is not radiated to the outside.
@5
●
This product uses a Class 3B laser regulated under JIS C 6802 (2005). Looking
directly at the laser will result in blindness, and radiating the laser directly on the
skin risks causing skin damage. Do not attempt disassembly or modifications to
this product.
Note: Any control or adjustment using procedures other than the procedures
specified here risk exposure to dangerous laser radiation.
●
This product uses a laser diode for the internal particle judgment mechanism.
The laser diode by its nature has a relatively short life compared to other
semiconductor devices. Moreover, variations in expected life between individual
parts can be extremely large. As a result, the laser life could relatively short
depending on application conditions and parts variations.
●
When mounting the product, leave room for adequate working space around it.
Failure to ensure adequate working space will make it more difficult to perform
daily inspections or maintenance, which could eventually lead to system
shutdown or damage to the product.
●
Always check the Owner’s Manual and other reference materials for product
wiring.
●
When handling the product, wear protective gloves and a mask, safety glasses,
safety shoes, etc. to keep safety.
●
When the product can no longer be used, or is no longer necessary, dispose of it
appropriately as industrial waste.
●
Since this product uses resistance-generated heat to generate a rising air flow
inside the case, always use it positioned perpendicular to horizontal (within
±
3°).
●
Since disturbances in air flow inside the case can have an effect on device’s
characteristics, use the CC monitor in an environment with a wind speed of
0.2m/s or less.
※
Koganei cannot be responsible if these items are not properly observed.
General Precautions
●
Do not apply excessive external force on the product.
●
When mounting, be careful to avoid twisting or distorting the device. Twisting or
distortion in the mounting position can result in defective operation.
●
If a breakdown occurs, adjustment and repairs will be needed. In such cases,
always be sure to contact Koganei.
@6
