Kogan KAHUDQ7GPSB, User Manual

Page: 5 / 12

Before First Use
1. Place the non-slip mat on the driver’s side corner of the dashboard and then place
the head up display (HUD) on it.
2. Connect the charger to the USB charging port and plug it into your car’s 12V power
socket (cigarette lighter).
3. Place the power switch in the on position.
Note: Once the HUD’s switch has placed in the on position, it is designed to
automatically power on and off with the vehicle’s accessory power.
4. Start the engine and the HUD will power on and the satellite indicator will begin
flashing.
5. Once the HUD has located a satellite, the indicator will stop flashing and turn solid,
the HUD is ready for use.
Reflective Film
The HUD projects information up onto the windscreen. Due to the construction of your
windscreen, the HUD may create a double reflection on the windscreen, which will make it
difficult to read. If this occurs, install the reflective film.
1. Spray some water onto the inside of your windscreen above where the HUD is
installed. Clean the area with a dry cloth.
2. Remove the backside (marked 1) of the film and apply to the windscreen.
3. Ensure the film is installed in the correct location and adjust if necessary.
4. Use a flat plastic object (credit card) to squeeze out any water or bubbles from
behind the reflective film.
5. Remove the protective film (marked 2).
6. If the reflective film isn’t positioned to display all the vehicle information, adjust the
position of the HUD and non-slip mat until it is correctly aligned.
INSTALLATION