4
START UP AND OPERATION:
PUMP
1
Remove the shipping plug on your pump’s crankcase and install the provided vented
plug / dipstick (yellow).
WARNING:
The vented plug / dipstick must be installed, by not doing so, may
cause personal injury, cause damage to the pump, and void its warranty.
2.
Check your pump oil level using the sight glass located on the side of the pump.
The oil should be 1/2 way up on the sight glass of the dipstick provided.
ENGINE
WARNING:
Do not operate before adding oil to engine (see Honda Engine Owner’s
Manual).
1.
Add SAE 10W30 motor oil to engine to the indicated appropriate level on your
dipstick. (See Honda Engine Manual for alternate oils)
Note
: Your engine is equipped with“low oil” shut-off. If there is not enough oil, the
engine will automatically shut off. (See Honda Engine Manual)
2.
Use UNLEADED gasoline only.
CONNECTIONS
.
When making any connections, do so with the pressure in the system relieved, the
engine “OFF”, and the red safety latch engaged on the trigger gun.
WARNING:
Failure to properly connect the high pressure hose, wand, and spray
nozzle can result in injury.
1.
Connect the wand to the spray gun with at least 8 wraps of TEFLON TAPE on the
threads.
2.
Models with dual lances come with 3 quick connect nozzles (0
°
, 15
°
, 25
°
nozzles)
and a soap nozzle already installed on the dual lance (when replacing this soap
nozzle, use TEFLON TAPE on the threads). Models with single lances come with 4
quick connect nozzles. Model C5050BG does not include quick connect nozzles.
Select the desired quick connect nozzle.
(RED) 0
°
gives a straight stream
(YELLOW) gives a 15
°
degree fan pattern
(GREEN) gives a 25
°
degree fan pattern
(BLACK) Soap (ONLY ON SINGLE LANCE MODELS)
