6
7.
Starting the engine with re-coil start (see Engine Manual).
•
Turn switch to “ON “ position.
•
Turn fuel knob to “ON” position.
•
Put engine throttle to full RPM’s (maximum) for proper pump
performance.
•
Turn on choke.
•
Pull engines starter until started.
•
Turn off choke.
Starting the engine with electric start (see Engine Manual).
•
Install battery as shown in Engine Manual (Battery not included).
•
Turn switch to “ON “ position.
•
Put engine throttle to ¾ RPM’s open.
•
Turn on choke.
•
Turn and hold key switch in the “START” position until started.
•
Once engine has started release key and turn choke off.
8.
By turning the unloader valve clockwise, it will increase the pressure. After starting
the engine you may increase the pressure via the unloader knob.
The pressure can be reduced by turning the unloader knob all the way in a
counter-clockwise direction.
PRESSURE WASHING
1.
To begin spraying and high pressure washing, disengage safety latch on the gun,
and trigger the gun.
WARNING:
To avoid injury always engage the red safety latch located on the spray
gun when not in use or when not spraying.
2.
The spray pattern of the high pressure spray can be changed by selecting another
quick connect nozzle which has been supplied.
3.
To change the quick connect nozzle selection, follow the instructions: (NOT
APPLICABLE TO C5050BG).
When installing or changing any spray nozzles, always do so with the water turned off
at the source, the pressure in the system relieved, the engine “OFF”, and the red
safety latch engaged on the trigger gun.
Always point the gun / wand away from you while connecting or disconnecting the
nozzle.
