8
RINSING AND PRESSURE WASHING
1.
Stop spraying.
2.
Engage red safety latch on the trigger gun.
3.
Take the chemical suction hose out of the detergent bottle.
4.
Disengage red safety latch on the trigger gun.
5.
For models with dual lance: With the dual lance pointed away from you, turn the
black side handle of the dual lance in a clock wise rotation. This will stop the
detergent injection.
For units with single lance. Remove Black quick connect nozzle and install desired
quick connect nozzles as described in “CONNECTIONS” Section of this Manual.
6.
Start spraying.
STOPPING
1.
Switch “OFF” engine (see Engine Manual).
2.
Turn off water supply at the source.
3.
Pull the trigger to release any left over pressure in the system.
4.
Engage red safety latch on trigger gun.
5.
Disconnect all hoses and store equipment on the cart.
STORAGE
In climates with winter conditions, extra precautions will be required to store the unit. If
possible, store the unit in a location free from freezing.
If the unit will be stored in a location where freezing may occur, follow these steps:
1.
Disconnect, and drain all hoses.
2.
Turn engine on for several seconds to remove any excess water in the pump.
3.
Using a short piece of hose with a male garden hose fitting attach it to the inlet fitting
on your pump. Making sure the hose is upright, fill it with a 50/50 mixture of
automotive coolant anti-freeze and water. Keep the hose upright and turn on the
engine for several seconds in order to get the mixture into the pump. When the
outlet fitting spits out the antifreeze solution it has been distributed throughout the
pump and you may stop. Your unit is now protected from freezing.
