Koden MDC-2240, Operation Manual

Page: 89 / 129

Chapter 4 Menu operations MDC-2200/2500 Series
0093125002-05 4-36
How to AIS target track
1 Select [CHART] => [PAST CRS 1 to 30] => [AIS], then press [ENT] key.
2
Move cross cursor using [Joystick] to lay on the target to be memorized, and press [ENT] key.
3
To discontinue memory, move cross cursor using [Joystick] to lay on the target, and press [ENT]
key.
Also [OFF] or [DISP] is selected.
(3) Setup track memory interval
Set up track memory interval (time).
Setting value: OFF, Continuous, 15sec, 30sec, 1min, 3min, 6min and 12min
When interval is shorten, detailed track can be memorized but memorable distance becomes short.
When interval is set longer, long distance can be memorized but track display becomes rough.
(4) Delete track
Delete memorized track.
Select track number to delete by the menu of track display number and then execute deletion.
(5) Setup Way point/route
When waypoint/route information is provided by GPS or by plotter, it can be displayed on the radar
screen as waypoint/route.
Waypoint is displayed by mark in the screen.
Input sentence necessary for way point display is “RMB” or “BWC”.
Input sentence necessary for route display is “RTE” or “WPL”.
ID of Way point/route can be displayed. Refer to (20) Display Waypoint/Route ID.
Flag mark can be displayed on Way point. Refer to (21) Display flag mark on waypoint.
(6) Display mark
This Device is provided as a mark input function 20 block and each block is capable to accept input of
50 points. Set to “ON” to display mark on the radar screen.
Note: Latitude/longitude and heading signal are required to use mark function.
(7) Select block number for mark display
Select block number of mark display. (1 to 20)
Mark of selected block number is displayed, and additionally input mark data is also registered to this
selected block number.