Kodak i800 Series, Instruction Manual

Page: 16 / 25

Versitec 1- 888 - 722 - 6548 www. versitec.com
13
4 Get the lower imaging guide that was set aside previously.
Clean the lower imaging guide with a clean, soft, lint-free cloth
slightly moistened with water. Lightly wipe both sides with a
Staticide wipe.
5 Reinstall the lower imaging guide. Make sure the notched
side is facing down and that the imaging guide is pushed in
all the way and fully seated in its slot.
6 Close the bi-fold door.
II.
i800 Maintenance & i800 Maintenance & i800 Maintenance & i800 Maintenance & i800 Maintenance &
replacement procedures replacement procedures
replacement procedures replacement procedures replacement procedures
This section provides procedures for replacing the following parts.
Use the list below as a guideline for frequency of replacement.
•
Feed Module Tires and Separation Roller – tire life will vary
depending upon paper types, environment and cleanliness. Nominal
tire life will be approximately 250,000 documents; results will vary.
Degradation of feeder performance, multiple feeds, stoppages, etc.
indicate a need to change tires. Change all the tires on the feed
module and separation roller at the same time.
•
Feed Module Separation Roller – it is recommended that you
install a new feed module approximately every 5th tire change.
See the checklist included in the Replenishment Kit. Install a new
feed module and separation roller at the same time.
•
Pre-separation Pad – change each time you change the tires
on the feed module and separation roller.
•
Exposure Lamps – it is suggested that all four lamps be replaced
every 500 hours of operation or as necessary (i.e., as reported by the
scanner, repeated image calibration failures, etc.)
•
Imaging Guides – replace when the imaging guides are heavily
scratched and defects show in the image.