A-61626 January 2010
25
•
: Content amount will be filled in with the amount of content in the
preview image. If you have a representative blank document (e.g.
blank sheet with letter head), this can be used to assist with
determining the setting for Content amount (i.e. perform a preview
scan, click this button, and adjust Content amount as appropriate).
NOTE: This option is only available when there is a preview image.
•
Based on Size
: images will be considered blank based on the size of
the image that would be given to the scanning application (i.e. after
all other settings have been applied).
-
Final image size
: allows you to select the minimum image size
that the scanner will consider to be non-blank. Any image that is
less than this value will be considered blank and will not be given
to the scanning application. The values range from 1 to 1000 KB
(1 KB equals 1024 bytes).
Image Edge Fill
— fills the edges of the final electronic image by
covering the area with the specified color.
•
Color
: allows you to select the color to fill the edges with.
- (none)
- White
- Black
•
All side match
: when turned on, an equal amount will be filled in on
all sides.
•
Top
: determines how much of the top edge will be filled in.
•
Left/Right:
the option on the left will determine how much of the left
edge will be filled in and the option on the right will determine how
much of the right edge will be filled in.
•
Bottom
: determines how much of the bottom edge will be filled in.
NOTES:
• The
Top, Left/Right
and
Bottom
options are not available when
All
sides match
is turned on.
• When using
Image Edge Fill,
be careful not to enter a value too
large as it could fill in image data that you want to keep.
Streak Filter
— allows you to configure the scanner to filter vertical
streaks from your images. Streaks are lines which may appear on an
image and are not part of the original document. Streaks may be
caused by contaminants on your documents (e.g. dirt, dust, or frayed
edges) or by not following the recommended cleaning procedures for
your scanner.
•
On:
turns streak filter on.
•
Aggressiveness
: allows you to adjust the extent at which the streaks
are filtered. The values range from -2 to 2. The default is 0.
