7
N
e
w F
eat
ures
Dual Slots for PC Cards
The second PC Card slot has been enabled on the DCS 330 camera. With Type II PC
Cards, you can use one or both slots. With Type III PC Cards, only one slot can be used.
The card in the rear slot is referred to as CARD0, and the card in the front slot as CARD1.
Insert PC Cards as described in chapter 4 of the User’s Manual. When using one PC Card,
you can use either slot. When using two cards, the first card inserted will be the active
card. When you capture or delete images, they will be saved to or deleted from the active
card.
With two PC Cards inserted, the following procedures are slightly different than those
described in the User’s Manual. (With one card, refer to chapter 4 of the User’s Manual.)
✔
Selecting a PC Card or folder (page 8)
✔
Deleting images (page 9)
✔
Formatting a PC Card (page 10)
IMPORTANT:
✔
Your camera uses 3 volt or 5 volt PC Cards. When you use two cards, they must
both have the same voltage rating. If you insert two cards with different
voltages, neither is powered. A “Card Voltage Mix” message appears. You need
to remove one of the cards so that the other can be powered.
✔
After inserting one PC Card, wait for the PC Card Busy/Record LED to stop
blinking before inserting the second card. Failure to do so will cause an error.
CARD0
CARD1
