Kobold NUS-4x04, Instruction Manual

Page: 14 / 40

NUS-4
Seite 14 NUS-4 K05/0216
8.3.3 GET LEVEL Function
Special function used only in level and distance measurement modes UP
+ DOWN
Notes:
If after pressing ENTER
E
blinking does not spring over from the parameter address to
the parameter value this means that

the parameter is either a read-out type, or

the secret code prevents the modification (see P99)
If the modification of the parameter value is not accepted i.e. the parameter value keeps
blinking after pressing ENTER
E
,

the modified value is either out of the range, or

the code entered is not a valid code
8.3.4 INDICATIONS OF THE NUS-400P AND LED STATUS
LED Indication

VALID (ECHO)
-LED
Lit in case of valid echo

RELAY
-LED
ON, when the “C2” circuit of
the relay is closed
NUS-400P indications
Depending on the measurement
one of the below symbols will lit
and the process value displayed
(see P01 chapter 9.1).
Engineering units will be
indicated directly (°C, °F and mA)
and by the lit arrow showing
towards them on the frame

DIST distance

LEV level

VOL volume

FLOW flow

T1/T2 totalised values

FAIL (blinking) Error code
displayed
For paging readouts NEXT
key should be pressed.
The following process values can be
displayed

Volume / Flow – if programmed so

Level – if programmed so

Distance – if programmed so

Warning indications – FAIL blinking
Display screens can be scrolled by pressing
key NEXT .
To return to the screen of the selected
measurement mode key ENTER
E
should
be pressed (see P01 chapter 6.1)
Temperature can be displayed by pressing
UP .
(°C/°F)
Current output value can be displayed by
pressing DOWN .
(mA)
(Vol/Flow)
(Distance)
(Error)
See
for possible readouts
P01