NUS-4
NUS-4 K05/0216
Seite 11
Damping time setting
(Check for a valid echo as above)
Action
Led state following the action
1) Press
ENTER
E
button
steadily
=
NUS-4 in programming mode
2) Press any of the NEXT
, UP , DOWN
buttons steadily
– 10 sec
= – 30 sec
– 60 sec
3) Release buttons
= Programming completed
RESET
:
Returning to the default (Check for a valid echo as above)
Action
Led state following the action
1) Press NEXT button
steadily
= NUS-4 in programming mode
2) Press ENTER
E
button
steadily
= Default loaded
Indication of mistakes (by LEDs) made during programming
Action
Led state following the action
Possible correction
Attempted programming
= blinking twice = no Echo
Find a valid Echo
Attempted programming
= blinking three times = no access
possible
With NUS-400P only See 8.3 (P99)
Attempted programming
= blinking four times = NUS-4 not in
Level Measurement Mode
With NUS-400P only See 8.3 (P01)
8.3 Programming with the Display Module NUS-400P
All features of the unit can be set, such as measurement configuration and
optimisation, 32-point linearisation, dimensions for 11 tanks with different shape
and for 21 different open channels (flume, weir, etc).
Devices with the type number NUS-xxxx xx xxP are already equipped with the
display module.
The NUS-4 is also fully operational without display module. The module is only
needed for programming and/or displaying measurement values.
The unit will measure during programming in accordance with the previous
parameters. The new, modified parameters will only be effective after returning to
the Measurement Mode
If the transmitter is left in Programming Mode by mistake, it will automatically return
to Measurement Mode after 30 minutes and will operate with the parameters
entered during the last completed programming.
