HND-P210
HND-P210 K08/0422
page 7
Max Memory:
Pressing ´max´ (key 2) shows the maximum of the measured
values. Pressing it again hides them. To clear the max
memory press key ´max´ for >2 seconds.
Min Memory:
Pressing ´min´ (key 5) shows the minimum of the measured
values. Pressing it again hides them. To clear the min
memory press key ´min´ for >2 seconds.
Hold Function:
By pressing ´Store/Quit´ (key 6) the last measuring value will
be held in the secondary display. Pressing it again hides it.
(only when logger = ‚off‘).
Zero-Point Adjustment:
If there is no pressure or zero-pressure (absolute)
applied to the pressure ports the device will display 0. If there
is a permanent deviation (and device is operated under
steady conditions), a permanent zero point adjustment can
be carried out.
To carry out the adjustment press button 3 for approx. 5
seconds. (Auto Null will be displayed shortly). The adjustment
is done via the OFFSET-value of the sensor (referring
configuration menu).
Note: A zero-point adjustment can only be carried out if the
difference between the value on display is less than 500
digits!
To recall the manufacturer`s calibration press button 3 for approx.
15 seconds.
Note: If a zero-point adjustment was carried out, this will be
signalled by the short displaying of „Corr“ when switching on
the device.
8.4 Configuration
To change device settings, press
Menu
(key 4) for 2 seconds. This will call the
configuration menu (main display: „SEt“).
Pressing key
Menu
changes between the menus, pressing
(key 3) jumps to the
referring parameters, which can be selected with key
(key 3).
The parameters can be changed with
(key 2) or
(key 5).
Pressing
Menu
again jumps back to the main configuration menu and saves the
settings.
Quit
(key 6) finishes the configuration and returns to standard measuring
operation.
