RC DALI is locked: Press " " or " " button to start dimming, then
again pressing " " or " " button to stop dimming while the light
level matches user′s desire, but the value will not be saved in detector,
and it will be dimmed automatically according to last Lux setting value
while the light is switched on next time.
RC DALI is unlocked: Press " " or " " button to start dimming,
then again pressing " " or " " button to stop dimming while the
light level matches user′s desire and the value will be saved in
detector as pre-set value, and it will be dimmed to this light level
automatically while the light is switched on next time.detetor como
valor predefinido e será escurecido para este nível de luz
automaticamente quando a luz voltar a ser ligada.
KDP-DALI 01
Presence detector for DALi lighting control
34
Instructions manual |
www.grupotemper.com
Manual dimming via external push button
Dimming via RC DALI remote control
•
•
Max. 10pcs slave detectors can be respectively connected in parallel to the
"R/S" terminal of the master detector KDP-DALI 01/KDP-DALI 01-C to
expand detection range if detection range of one KDP-DALI 01/
KDP-DALI 01-C does not meet user′s requirement. Slave detector can only
be used to transfer detecting signal to master detector for expanding the
detection range, the connected loads will only act according to the pre-set
values of master detector.
Detector can dim the light level of lighting manually via operating the
push button connected to "R/S" terminal. Press (2sec) the push button,
the light level of the load will change, then release the push button while
the light level of the load matches the desired value.
Remark: It will lead to opposite dimming direction if next dimming is
carried out.The dimming way is unidirectional and non-recyclable.não é
reciclável.
Detector enters into semi-auto mode by pressing " " button on
RC DALI .
Under semi-auto mode, load can only be manually switched on by
operating external push button.
When the load is switched on, it will keep be on if the movements
are detected constantly. Load will turn off if no movement is detected
and the delay time has expired.
Load can also be manually switched off by operating external push
button.
Semi-auto mode (Operation with RC DALI only)
•
•
•
•