KNX AQS-UP basic, Installation And Adjustment Manual

Page: 14 / 26

13 Parameter setting
Sensor KNX AQS-UP basic • from software 3.1 • Status: 24.03.2016 • Technical changes reserved. Errors reserved.
4. Parameter setting
4.1. Behaviour on power failure/ restoration of
power
Behaviour following a failure of the bus power supply:
The device sends nothing.
Behaviour on bus restoration of power and following programming or reset:
The device sends all outputs according to their send behaviour set in the parameters
with the delays established in the "General settings" parameter block. The "Software
version" communications object is sent once after 5 seconds.
205 OR logic 7: 1-bit switching output Output 1,002 C R T
206 OR logic 7: 8-bit output A Output 5,010 C R T
207 OR logic 7: 8-bit output B Output 5,010 C R T
208 OR logic 7: Block Input 1,002 C W
209 OR logic 8: 1-bit switching output Output 1,002 C R T
210 OR logic 8: 8-bit output A Output 5,010 C R T
211 OR logic 8: 8-bit output B Output 5,010 C R T
212 OR logic 8: Block Input 1,002 C W
213 Logic input 1 Input 1,002 C W
214 Logic input 2 Input 1,002 C W
215 Logic input 3 Input 1,002 C W
216 Logic input 4 Input 1,002 C W
217 Logic input 5 Input 1,002 C W
218 Logic input 6 Input 1,002 C W
219 Logic input 7 Input 1,002 C W
220 Logic input 8 Input 1,002 C W
221 Logic input 9 Input 1,002 C W
222 Logic input 10 Input 1,002 C W
223 Logic input 11 Input 1,002 C W
224 Logic input 12 Input 1,002 C W
225 Logic input 13 Input 1,002 C W
226 Logic input 14 Input 1,002 C W
227 Logic input 15 Input 1,002 C W
228 Logic input 16 Input 1,002 C W
No. Name Function DPT Flags