ADJUSTING
6
B
E
C
D
A
6. Changing the band saw blade.
WARNING
Saw blade is dangerous. Be sure to
wear gloves when handing saw blade in situations
such as removing from packaging, mounting or replacing
blade.
• Remove
the D-nut,
washers, and
wing screw
on the saw table.
• Open the upper
cover and lower cover.
• Set the upper blade guide to its lowest position.
• Open the cover of upper guide assembly.
• Loosen blade tension knob.
• Remove the band saw blade from the machine.
• Fit a fresh band saw blade and center band saw blade
on the rubber tyres of the band saw wheels.
• Retighten blade tension knob.
• Replaced the D-nut, washers, and wing screw.
• Close the upper and lower cover.
Close the cover of upper guide assembly.
• Then: Align the saw blade.
Adjust the blade tension.
Adjust the upper blade guide and lower
blade guide.
D-nut
Wing
screw
Upper
cover
Lower
cover
The cover of
upper guide
Blade
tension
knob
Open the cover of upper guide:
Loose the locking knob, then
turn the adjusting knob to turn down the upper guide cover,
then Move the bottom of the guard to open.
Adjusting
knob
Locking
knob
5. Align the lower blade guide
The lower blade guide needs to be readjusted after every
band saw blade change or tracking adjustment.
• Through the hole (B) and (E), use hex wrench to
loosen socket bolts, adjust guide block (D) and thrust
bearing (C) just like adjusting upper blade guide.
• Loosen the screw (A), and adjust the guide bearing
to a position 0.2mm away from blade. Retighten
the screw (A).
