9
8
4
6
2
3
3
INSIDE
VIEW
remove knockouts
3. The accessory kit supplied with the dish machine contains the door strap and fasteners required to convert
the machine. Table below describes part provided for conversion in this kit.
2. Make sure sump screen is in place over the pump
intake tube so no parts fall in to the pump! Remove
the two knockouts on the front door. One is located in
the center and the other is directly below the right
side door stop bumper. Remove one knockout directly
below bumper on right side door.
Page No. 5
(11/01) Revision F, EO 4109 Part No. 9641606
6
4
2
6
2
9
INLINE OR CORNER DOOR CONVERSION
Conversion from inline to corner can be done by changing the location of the tray stop on the tray rails and install-
ing door conversion bracket and screws in the accessory kit. Two 7/16 wrenches will be needed to make the con-
version.
Conversion of the machine is easier
if done before tabling is attached.
Machines are factory set in the
inline configuration.
1. Remove the two (A) bolts/nuts
securing the tray rail stop located
on the tray rail and reposition to
desired configuration.
2
A
1
1
1
1
5
7
