Water level
INITIAL OPERATION
1. Check pump intake screen for proper installation.
2. Start with all switches in the OFF position
3. Turn on main power switch. With
doors closed, flip-up the fill button to
fill the dishwasher with fresh 140 deg.
F water (120 F min.). Fill until level
with top of drain ball tube.
4. Turn ON the RUN POWER switch and with doors in closed position the machine will start to wash. Allow
machine to run through one cycle and watch machine sequence through the following wash cycle: (90 second
cycle evaluated ). Machine can be adjusted to 120, 90 or 72 second cycles. See below and page 4 for more de-
tails. (Cycle adjustments will need to be done by authorized personnel only.
1 second – wash pump motor turns on
3 seconds – detergent pump runs for adjusted period of time.
45 seconds – drain opens and machine drains for 15 seconds.
Adjustable 48 to 60 seconds – fresh water valve opens and rinses inside of dishwasher
(drain is still open)
60 seconds – drain closes and fill remains open for period of time to fill dish machine.
70 seconds – sanitizer and rinse pumps run for an adjustable period of time.
70 seconds – wash pump motor stops for three seconds then starts to “burp” the
machine.
90 seconds – machine will stop. This is the end of the wash cycle.
5. Machine is factory adjusted but may need to be adjusted to local water pressure to operate properly.
TIME
0
10
20
30
40
50
60
70
80
90
Page No. 2
Hook tab under rod
(11/10/01) Revision F, EO 4109 Part No. 9641606
