KMT STREAMLINE S30, Operation And Maintenance Manual, Page: 245 / 261

agents and combustible materials. Do not store near heat,
sparks, flame or strong oxidants.
SPECIAL PRECAUTIONS: Prevent small spills and leakages to avoid slip
hazard.
EMPTY CONTAINER WARNING: Empty containers retain residue (liquid
and/or vapor) and can be dangerous. DO NOT PRESSURIZE, CUT, WELD,
BRAZE, SOLDER, DRILL, GRIND OR EXPOSE SUCH CONTAINERS TO HEAT,
FLAME, SPARKS, STATIC ELECTRICITY, OR OTHER SOURCES OF IGNITION;
THEY MAY EXPLODE AND CAUSE INJURY OR DEATH. Do not attempt to
refill or clean container since residue is difficult to remove.
Empty drums should be completely drained, properly bunged and
promptly returned to a drum reconditioner. All containers should
be disposed of in an environmentally safe manner and in
accordance with governmental regulations.
--------------------------------------------------------------------------
8. EXPOSURE CONTROLS/PERSONAL PROTECTION
--------------------------------------------------------------------------
OCCUPATIONAL EXPOSURE LIMITS:
When mists/aerosols can occur, the following are recommended: 5 mg/m3
(as oil mist)- ACGIH Threshold Limit Value (TLV), 10 mg/m3 (as oil mist)
- ACGIH Short Term Exposure Limit (STEL), 5 mg/m3 (as oil mist) - OSHA
Permissible Exposure Limit (PEL)
VENTILATION: If mists are generated, use adequate ventilation, local
exhaust or enclosures to control below exposure limits.
RESPIRATORY PROTECTION: If mists are generated, and/or when
ventilation is not adequate, wear approved respirator.
EYE PROTECTION: If eye contact is likely, safety glasses with side
shields or chemical type goggles should be worn.
SKIN PROTECTION: Not normally required. When splashing or liquid
contact can occur frequently, wear oil resistant gloves and/or
other protective clothing. Good personal hygiene practices
should always be followed.
--------------------------------------------------------------------------
9. PHYSICAL AND CHEMICAL PROPERTIES
--------------------------------------------------------------------------
Typical physical properties are given below. Consult Product Data Sheet
for specific details.
APPEARANCE: Liquid
COLOR: Amber
ODOR: Mild
ODOR THRESHOLD-ppm: NE
pH: NA
BOILING POINT C(F): > 316(600)
MELTING POINT C(F): NA
FLASH POINT C(F): > 204(400) (ASTM D-93)
FLAMMABILITY (solids): NE
AUTO FLAMMABILITY C(F): NA
EXPLOSIVE PROPERTIES: NA
OXIDIZING PROPERTIES: NA
VAPOR PRESSURE-mmHg 20 C: < 0.1
VAPOR DENSITY: > 2.0
EVAPORATION RATE: NE
RELATIVE DENSITY, 15/4 C: 0.875
SOLUBILITY IN WATER: Negligible
PARTITION COEFFICIENT: > 3.5
VISCOSITY AT 40 C, cSt: 68.0
KMT 20416091