4 I English
3426
1
TECHNICAL DATA
Type
3426
Dimensions mm
280/345
Weight kg (without fasteners)
2,2 kg
Contact actuation
Recommended operating pressure
range
5 - 8.5 bar/
0.5 - 0.85 MPa
Maximun permissible operating
pressure
8.5 bar/
0.85 MP
Air consumption per driving
operation
2.7 l at 6
bar / 0.6 MPa
Magazine capacity No. of fasteners
140
Penetration depth setting
yes
Fastener: Staples G
Staple length mm
25 - 50
Wire thickness mm
1.4 x 1.65
Staple width mm
11.7
Recommended lubricant
1 litre special oil. Code No.
9 4420
250 cm3 grasa especial. Code No.
68 3868
2
NOISE/VIBRATION INFORMATION
Noise characteristic values *
3426
A-weighted single-event emission
sound pressure level at work
station L pA, 1s
83.9 dB(A)
A-weighted sound power level L
WA, 1s, d
96.9 dB(A)
Vibration characteristic values **
Weighted r.m.s.-acceleration (a)
3,15 m/s2
The noise level when working can exceed 85
dB (A). Wear ear protection!
*
Measured values determined according to
EN 12549:1999.
** Measured values determined according to
ISO 8662-11:1999.
3
SUPPLIED WITH
1 Stapler
1 Tool use and safety instructions
1 Technical data sheet
4
FILLING THE MAGAZINE
Only those fasteners specified under technical data
(see 1) may be used.
When filling the magazine, hold the tool so that the
muzzle is not pointing towards own body or towards
any other person.
Do not load the tool with fasteners with the safety
yoke or trigger depressed.
Pull the pusher (62A) back until it locks. Using the strip
of staples push aside the magazine covering (52) and
insert the staples. Finally release the pusher and slide
it manually towards the staples.
5
FIL PENETRATION DEPTH SETTING
The penetration depth of the nail head can be
controlled by means of the air pressure. If this is
not satisfactory, the penetration setting offers a
more accurate adjustment of the penetration depth.
Adjustment is only possible in the unpressurized
condition.
The penetration depth setting can be moved by one
or more notches by loosening the screw (44) and the
safety yoke (43). For safety reasons, this should only
be carried out in a depressurised state.
Retighten the screw.
6
ACCESSORIES
Code No.
Balancer for 20-30 N (2.0-3.0 Kp),
cable travel 2.0 m (6.5 ft)
40 3407
KMR
