Technical manual
360-drive page 13 of 26
2.
If all these things work properly, the 360 drive is ready for use. Should that not
be the case, please contact the technical department of Konga Mekaniska, before
using the 360 drive.
When 360 drive is not in use, remove the key from the ignition switch magnet
to exclude unauthorized persons driving the 360-drive. In addition put the 360
drive on the handbrake and disconnect any loads. .
The driver should only be on the 360 drive to take place at the appropriate
platform in the raised edges. The height of the platform is 130 mm. In the
driving routes, the minimum height of frames and / or ceilings or obstructions
on ceilings and / or frames to the floor have to be measured. Of this
measurement must be subtracted 130mm, this is the length allowed for
employees to be able to stand on the platform. If an employee is longer than
the allowed length of 360 he must drive and step on the floor temporarily until
the right height allows him to drive on the platform again.
5.2 Reversing the 360 drive.
Always keep in mind when reversing maintains a creep speed. Your control of
the machine is less when reversing.
5.3 Operation of 360 drive
When all inspections have been done as described in 5.1 you’re ready to drive.
While driving with 360 drive, always use two hands on the tiller for safe steering.
5.5 Use of the safety switch
The safety switch is located on the tiller and is clearly recognizable by its red color. (see
chapter 4.3 Control device) When the switch is pressed (in case of entrapment), the 360
drive stops.
5.6 Shutdown 360 drive
Turn off the 360 drive after use by taking off the magnetic key at the tillerhead.
Turn the machine off and remove the magnet key always from the ignition
switch before servicing the 360 drive to prevent dangerous situations or
serious injury.
When 360 drive is not in use, remove the magnetic key off the tillerhead to
avoid unauthorized persons driving the 360 drive.