Too short
Correct
Too long
3. Center the base over the top of the hole in the mounting location. From underneath the
surface, slide the flat clamping plate onto the M8 screw.
5. Installation of the monitor plate to the display
1. Carefully place your display face down on a soft, even surface, and identify the threaded
mounting points that are located on the back panel.
Note:
If a stand is attached to a monitor, it must be removed now.
2. Determine the correct screw size by carefully inserting a straw or toothpick, and mark the
depth of the mounting point. Please note that not all the hardware included will be used.
CAUTION:
Verify the adequate thread engagement of the screw/spacer combination on
your monitor. Too short will not hold the display and too long will damage it.
3. Using a phillips-head screwdriver, insert the first two screws and washers in the upper
mounting holes on the back of the monitor.
4. Use the wing nut to secure the assembly. Fasten the wing nut until the mount is firmly
attached to the desktop.
Note:
The M8 screw must be centered in the hole.
For security purposes and to avoid equipment damage, the base and the clamping plate must
make contact with the mounting surface on both sides of the hole.
Summary of Contents for KPM-312
Page 7: ......
