ILav65 Instruction Manual
lifted in parking position. After 15 seconds the extraction motor is stopped. This delay is
to allow for complete emptying of the
recovered solution which is still present in the extraction pipe.
4. Brake until the machine stops.
5. Turn the ignition key “OFF” or get off the machine.
5. The parking brake is automatically engaged.
12.4. DOUBLE WASHING and SINGLE DRYING
Particularly hard floors or with considerable accumulated dirt may not be sufficiently
clean with one pass only. In these cases double brushing must be performed.
To perform double brushing and washing, carry out a first pass with the wiper lifted by
acting on the manual cam located on the side of the steering column, solution flow
activated and brushes lowered. In this way the solution is in contact with the floor while
the brushes reduce the layer of dirt. Let
a reasonable length of time elapse so that the solution is sufficiently in contact with the
floor. The length of time elapsed between the
first and second pass depends on the amount of dirt and type of chemical used.
A second pass with wiper and brushes lowered and activated solution further reduces
the layer of dirt. A further application of solution contributes to making a hard cleaning
operation mush easier.
When double washing passes are performed, it is recommended to maintain a
particularly low driving speed due to the wet floor and in order to allow the detergent to
chemically act on the dirt.
12.5. EMPTYING AND CLEANING THE RECOVERY TANK
1. Press the switch on the control panel to lift the brush plate, stop the motor and flow of
solution and de-activate the extraction turbine.
2. Place the vehicle near a floor drain. The discharge pipe is at the rear of the machine.
3. Turn the ignition key to “OFF”, the parking brake is engaged.
4. Remove the clip from the discharge pipe. Unscrew the cap and lower the discharge
pipe towards the floor drain. Stay behind the end of the pipe. The recovered solution is
discharged at a significant pressure. Remove the discharge pipe cap slowly.
5. Remove the upper tank cover.
6. Wash the recovery tank with clean water. Repeat washing until clean water issues
from the discharge pipe. Do not use water at temperature higher than 50°C as it might
damage the tank.
7. Replace the cap and the discharge pipe.
8. If the machine must be left inactive for a long period of time do not reassemble the
recovery tank upper cover and the discharge pipe cap, to allow air to circulate inside it.
13/08/14 Rev: 2.0.
0 (
TRANSLATION FROM THE ORIGINAL
LANGUAGE)
27
Summary of Contents for ILav65
Page 9: ...ILav65 Instruction Manual 13 08 14 Rev 2 0 0 TRANSLATION FROM THE ORIGINAL LANGUAGE 9...
Page 25: ...ILav65 Instruction Manual 13 08 14 Rev 2 0 0 TRANSLATION FROM THE ORIGINAL LANGUAGE 25...
Page 35: ...ILav65 Instruction Manual 13 08 14 Rev 2 0 0 TRANSLATION FROM THE ORIGINAL LANGUAGE 35...