21
!
STEAM FUNCTION MANAGEMENT
!
"
NO WATER IN THE TANK
Usually, if the tank is filled with 1.1 litres of water, this should be enough for the entire
steam cooking cycle.
If not, the electronic system signals that the water is finished using an
intermittent audible signal and the corresponding water icon flashes
.
The oven automatically goes into pause
.
Open the door, remove the tank and fill with potable water. Close the door and de-
activate the pause by pressing the 3 START key
.
The oven will restart from where it stopped.
NOTE: if the steam puff function was activated, the system gives 5 mins to perform the
water refill procedure. Once the 5 mins have passed, the system automatically restarts
the traditional cooking cycle, de-activating the steam puff function.
"
DRAIN WATER FROM THE BOILER
At the end of any
steam cooking or cleaning cycle, the system always requires the water
to be drained from the boiler and thus the circuit. This keeps the system clean and
prevents lime scale from forming.
It is a quick and simple operation and keeps the circuit ready for a new steam cooking
cycle.
After cooking is complete, from the oven mode "on, awaiting commands", press the 1
ON/OFF key to turn the oven off.
An intermittent audible signal and the tank+water icon begin to flash
.
The oven does not turn completely off until the boiler
circuit is emptied.
