8
9. Explanation of the duplex key area
EDIT
area
[DELETE]
In program state, it is used to delete the chase or chase
step, and cancel the setup of the transfer channel.
Instantly press down: Delete the current chase step.
Press down for 3 seconds: Delete the current chase step, and
make it an empty program.
In the state of [SET X/Y] setting,pressing the [DELETE] key
will cancel the X-Y direction channel transfer.
[
- ]
In program state, it is used to turn to the previous page, to
view the last chase.
[ +
]
In program state, it is used to turn to the next page, to
memorize the current chase (adding a chase step) or to view
the edited chase.
[SET X/Y]
When just entering the edit state , immediately press [SET
X/Y], and according to the prompt on the LCD, select two
scanning channels corresponding to the scanner X-Y
direction from P1-P8 or PCH9-PCH16, and transfer to
control the yellow indicating light with the rocker
potentiometer, and then immediately press the [SET X/Y]
key again to memorize it and quit.
RUN
area
[CLEAR]
In any number key selection state in the running mode,
press [DELETE], and then immediately clear the
indication; it can be repeatedly selected.
In the running mode, all channel function data are
cleared to zero after pressing this key.
[CROSS MODE]
Mode 1:
When running the program, all the channel
data are running with the chase cross time
potentionmeter control.
Mode 2:
When running the program, the set X and Y
channel data is controlled by the chase cross time
potentiometer, and all the other channel data are in the
jumping state, so as to prevent the colors and patterns
that have not edited or memorized from playing in slow
scanning.
[SCENE]
When running the chase, press this key, and then
immediately select P1-P12, to call out the first 12 scenes in
No.1 chase, which are independently presented to be used as
special scenes. In order to quit the scene presentation state,
please press the [EDIT/RUN] key.
[RELEASE CHANNELS]
Press this channel release key, in coordination with
P1-P8 keys or SHIFT+(PCH9-PCH16) keys, will change
the data of channels CH1-CH16, in running the program,
