Instruction
Manual
PK
120/30 page
25
_____________________________________________________________________________
With those dies mentioned in Table 3a only Klauke cable lugs and connectors „Standard
type“ are supposed to be crimped. Crimping of commercial cable lugs and connectors of
other suppliers will not result in a perfect crimp.
The same is valid for conducting material table 3j. No guarantee can be given for crimping
C-clamps of other suppliers.
Despite the same code numbers the compression width for copper and aluminium cable lugs
and connectors is different. Besides the marking of the dies the plating is different too.
Attention
Even if the code number is identical only those dies should be used which are
suitable for the material.
5.4. Service and maintenance instruction
The hydraulic tool must be cleaned and dried after each use. The tool is maintenance free.
After one year we recommend sending the tool in to the manufacturer for an inspection.
5.5. Reference as to which spare parts can be exchanged by the customer
Within the determined use of the tool only the dies (Pos.-No. 2) are permitted to be changed
by the customer.
Instruction
Manual
PK
120/30 page
25
_____________________________________________________________________________
With those dies mentioned in Table 3a only Klauke cable lugs and connectors „Standard
type“ are supposed to be crimped. Crimping of commercial cable lugs and connectors of
other suppliers will not result in a perfect crimp.
The same is valid for conducting material table 3j. No guarantee can be given for crimping
C-clamps of other suppliers.
Despite the same code numbers the compression width for copper and aluminium cable lugs
and connectors is different. Besides the marking of the dies the plating is different too.
Attention
Even if the code number is identical only those dies should be used which are
suitable for the material.
5.4. Service and maintenance instruction
The hydraulic tool must be cleaned and dried after each use. The tool is maintenance free.
After one year we recommend sending the tool in to the manufacturer for an inspection.
5.5. Reference as to which spare parts can be exchanged by the customer
Within the determined use of the tool only the dies (Pos.-No. 2) are permitted to be changed
by the customer.
I
I