93
EN
After Installation
Check whether the requirements listed in the table are met or whether there are any
malfunctions:
To check
Possible malfunction
Has the device been securely installed?
The unit may fall, wobble or make a
noise during start-up.
Would a refrigerant leak test be
performed?
Insufficient cooling (or heating) capacity
could result.
Have the lines been sufficiently insulated?
Condensation and dripping water could
result.
Is the water drained correctly?
Condensation and dripping water could
result.
Does the mains voltage of the socket
correspond to the voltage indicated on
the appliance's nameplate?
Malfunctions may be caused or parts of
the unit may be damaged.
Have the electrical cables and lines been
installed correctly?
Malfunctions may be caused or parts of
the unit may be damaged.
Has the appliance been properly
earthed?
This could result in electrical leakage.
Does the power cord used meet the
manufacturer's requirements?
Malfunctions could be caused or parts of
the device could be damaged.
Are the air inlets and outlets blocked by
anything?
Insufficient cooling (or heating) capacity
could result.
Have dust and dirt residues been
removed during installation?
Malfunctions may be caused or parts of
the unit may be damaged.
Are the gas valve and liquid valve fully
open?
Insufficient cooling (or heating) capacity
could result.
Have the inlet and outlet of the pipe
opening been covered?
Insufficient cooling (or heating) capacity
or waste of energy could result.