73
EN
SLEEP (Sleep Mode)
When you press this button, you can select Sleep1(
), Sleep2 (
), Sleep3 (
)
and Sleep OFF. Press this button several times to select the desired profile.
Sleep1:
In cooling mode, when sleep function 1 is activated, the temperature of the
air conditioner is increased by 1 °C after one hour running time. After two hours of
operation, the temperature is increased by a further 2 °C. The unit then continues to run
permanently at this temperature. In cooling mode, when sleep function 1 is activated,
the set temperature is reduced by 1 °C after one hour running time. After two hours of
operation, the set temperature is lowered by a further 2 °C. The device then continues
operation with this temperature setting.
Sleep2:
In this mode, the unit runs according to the default setting of a group of sleep
temperature curves.
Sleep3:
In this mode, all settings can be made by the user.
1 At this time, the remote control time display shows [1 HOUR] and the corresponding
temperature of the last set sleep curve is displayed on the screen and flashes (the
first time the unit is used, the factory preset initial value of the sleep curve setting is
displayed).
2
Adjust the temperature by pressing the ARROW buttons and confirm your selection
by pressing the TURBO button.
3 At this time, the time position of the remote control is automatically increased by
one hour (this means: 2 HOUR, 3 HOUR , ...to 8 HOUR), the temperature display
shows the corresponding temperature of the last set sleep curve and flashes.
4 Repeat steps 2 and 3 until the temperature setting has been made for the entire 8
hours and the sleep curve setting has been completed. The remote control display
will then return to the original settings.
If you want to use an individualised setting for the sleep curve setting but do not want to
change the temperature, press the TURBO button to continue switching.
Note
: If no button is pressed within 10 seconds, the sleep curve setting is
automatically cancelled and the original settings are displayed. If you wish to cancel
the sleep curve setting, you can do so by pressing one of the POWER, MODE, TIMER
and SLEEP buttons.
