80
Installation
8.8 Securing the dishwasher
• The dishwasher should be attached to the worktop,
which can be done in one of two ways:
• Standard countertop
- Attach the dishwasher to the
bottom of the worktop with two wood screws.
• You should screw these screws through the holes in the
holders on the top of the dishwasher housing.
• These screws are to be tightened strongly.
• Worktop of marble / granite
- On these special work-
tops, the top of the dishwasher can not be attached
by screwing to the bottom of the worktop.
• There are rubber stops on both sides of the front edge
of the dishwasher. Remove them to clear the pre-drilled
holes on both sides of the dishwasher.
• Attach the dishwasher to the kitchen block on both sides
by tightening the wood screw screwed into the pre-
drilled holes. These screws must be tightened.
• Put the rubber stops in their position.
8.7 Balancing the dishwasher
!
• Make sure that the dishwasher is supported during
balancing, otherwise it could tip over.
• The rear foot is attached to a setscrew, which is adjusted
by turning.
• The front feet can be adjusted with a key.
• The permissible angle of the dishwasher is 2°.
For balancing use the spirit level.
• Check the balance of the device from side to side as well
as from the front to the back.
The dishwasher must be in balance to work properly.
Adjusting the
front feet
Adjusting the
rear foot
Note:
The strips supplied are designed to compensate
for the front panel height.
cap
