78
Installation
8.4 Water connection
Connection of the dishwasher to the water supply
Water drain
• The supply hose can be found inside the dish-
washer.
• Connect the supply hose to the tap, which has
the ¾ „thread and a supply hose clamp on the
appliance.
• Attach the supply hose to the tap and to the
dishwasher.
• Important:
In the supply hose is the electronic
AquaStop, which must be directed upwards, as
shown.
• Secure the drain hose so that
it can not move while the dish-
washer is running.
• Insert the end of the drain hose
into the drain pipe and push it
directly into the drain pipe (120
mm minimum).
IMPORTANT:
Do not insert the
drain hose too deeply into the
drain pipe, otherwise there is
accumulation of air in the trap.
Do not connect the dishwasher to the water supply using an old or
existing supply hose. The supplied supply hose is the only possible
hose that can be used.
DO NOT CONNECT THE SUPPLY HOSE TO THE HOT WATER TAP!
AquaStop
NOTE:
NEVER EXTEND THE ORIGINAL LENGTH OF THE DRAIN HOSE.
Hang the drain hose hook on the sink.
Caution:
The upper end of the
hose must be at a
height between 40 and
100 cm. The free end of
the hose must not be
submerged in water.
sink
drain hose hook