The actual product may differ from
the images in the manual.
- 9 -
Installation
■
Fuel S torage Device
The user shall provide a hopper-type storage
tank for storing wooden pellets to use the
product. The recommended minimum capacity
of the fuel storage tank is 300 liters (180 kg
of fuel).
■
C onnection of electric apparatus
(S ee page 6)
1. C onnecting the power cable
C onnect the power cable supplied together
with the product to the power supply cable
connection of Item 15.
Turn the s witch to "ON (-)" position under the
cord after connecting the power cable to
supply power to the product.
2. C onnection of feeder and circulation pump
Remove the terminal block cover on the
lower right of the burner, and then connect
the wires of the feeder and circulation pump
to the portion under the terminal block (4-pin)
as shown in the figure.
Finish the ends of the wires with Y-type
terminals.
Wiring shall be performed only
after shutting down power supply.
3. C onnection of low level sensor and
temperature sensor
C onnect the wires supplied together with the
product to the connections of the low level
sensor and the temperature sensor.
■
How to Install the Feeder
The exclusive feeder shall be used to obtain
correct output from the K RPB-20A pellet
burner.
The installation angle is critical when installing
the feeder.
1. C onnect the fuel hoses supplied together
with the product to the fuel feed port and the
discharge port at point A.
2. Make use of the stainless steel bands to
fasten the hoses securely to prevent leak of
air or fuel.
40±
A
60
Be sure to comply
with the dimens ions and
instructions below.