KitchenAid KUDD03DT, Technical Education

Page: 35 / 70

3-5
IMPORTANT: The sensor in your dishwasher monitors the soil level. Cycl e time and/or water usage can vary as the sensor adjusts the
cycle for the best wash performance. If the incoming water is le ss than the recommended temperature or food soils are heavy, th e cycle
will automatically compensate by adding time, heat and water as needed.
To run your dish washer at
a later time or during off-
peak hours.
Delays the start of a cycle up to 4 hours.
Select a wash cycle and options. Press 4 Hour Delay. Press
START/RESUME. Close the drawer firmly.
All cycles, except Rinse
Only
Control Lock To avoid unintended use of
your dishwasher, or cycle
and option changes during
a cycle.
To turn on Lock, press and hold ProDry for at least
4 seconds.
To turn off Lock, press and hold ProDry for at least
4 seconds.
When Control Lock is lit, all bu ttons are disabled. If you press
any pad while your dishwasher is locked, the light flashes
3 times. The dishwasher drawer can be opened while the
controls are locked.
Anytime
OPTION SELECTIONS
: H T I W E S U S N O I T P I R C S E D S E P Y T D A O L H S I D S N O I T P O
CONTROLS AND
CYCLE STATUS
CONTROL PURPOSE COMMENTS
To start or resume a
wash cycle
If the drawer is opened during a cycle or the power is interrupted, the Start/Resume indicator
flashes. The cycle will not resume until the drawer is closed and Start/Resume is pressed.
To cancel wash
cycle
Close the drawer firmly. The dishwasher starts a 2-minute drain (if needed). Let the dishwasher
drain completely.
To follow the
progress and status
of your dishwasher
cycle
Clean indicator glows when a cycle is finished.
If you select the Sani Rinse option, when the Sani
Rinse cycle is finished, the Sanitized indicator
glows. If your dishwasher did not properly sanitize your dishes, the light flashes at the end of the
cycle. This can happen if the cycle is interrupted, or the water could not be heated to the required
temperature. The light goes off when you open and close the drawer or press CANCEL.
Rinse aid low indicator light glows when the
rinse aid dispenser needs to be refilled.