2-5
REMOVING THE LOW VOLTAGE TRANSFORMER,
THE LIGHT POWER SUPPLY, & SUPPRESSOR BOARD
1.Disconnect the electrical power to the
microwave oven.
2.Remove the microwave oven assembly
from its mounting location (see page 2-2
for the procedure).
3.Remove the screw from the power conduit
clamp and remove the clamp.
4.Remove the 10 screws from the top front
and top rear oven cabinet covers.
CAUTION:
When you work on the microwave
oven, be careful when handling the sheet metal
parts. Sharp edges may be present, and you
can cut yourself if you are not careful.
5.
To remove the low voltage transformer:
a) Disconnect the 10-hole connector from
the control board at P17.
b) Remove the mounting screw at the top
and unhook the bottom transformer tab
from the oven cabinet slot.
6.
To remove the light power supply:
a) Disconnect the four wires from the LINE
and LOAD terminals. Note that the LINE
terminals are smaller than the LOAD
terminals to prevent miswiring.
b) Remove the mounting screw and un-
hook the tab from the oven cabinet slot.
Screw
Light Power
Supply
Line & Load
Wires
Screw LV Transformer Connector P17
Continued on the next page.
Conduit
Clamp
Top Front Cover
(4 Screws)
Top Rear Cover
(6 Screws)
Electrical Shock Hazard
Disconnect power before servicing.
Replace all panels before operating.
Failure to do so could result in death or
electrical shock.
WARNING
Summary of Contents for KAC-24
