Back right corner:
If countertop is more than
3/4" (1.9 cm) thick, measure
down 3/4" (1.9 cm) and cut 45°
bevel all the way around
radius.
3
Cabinet dimensions
Product dimensions
19-3/8"
(49.2 cm)
maximum
opened lid
height
20-21/32" (52.5 cm)
9-7/16"
(24.0 cm)
1-3/4" (4.4 cm)
to center of
single hole
faucet
factory
installed
air gaps
dishwasher
drain
water inlet
valve
(between clamp rails)
22" (55.9 cm)
(between clamp rails)
5-25/32"
(14.7 cm)
39-11/16" (100.8 cm)
14" (35.6 cm)
18-5/16" (46.5 cm)
22-1/32"
(56.0 cm)
21"
(53.3 cm)
1-1/4"
(3.2 cm)
8"
(20.3 cm)
9-9/16"
(24.3 cm)
center of
sink drain
5-1/2 ft. (1.7 m)
3-prong ground-type
power supply cord
16-7/8" (42.9 cm)
to center of
single hole faucet
A
*
NOTE:
The cutout must be accurately cut to the dimensions shown
within 1/16" (1.6 mm). Dishwasher top flange overlaps the
countertop cutout by 7/16" (1.1 cm) on front and back edges and 1/4"
(6.4 mm) on sides.
• Cabinetry and countertop must be sturdy enough to support
loaded dishwasher and sink (400 lbs. [181.4 kg]).
IMPORTANT:
Corner radius dimensions
specified must be used. If they are not,
the dishwasher will not fit the opening.
radius: 2-1/4" (5.7 cm)
C
3/4"
(1.9 cm)
45°
for base cabinet
installations, min. 42"
(106.7 cm) width required
21-1/8"
(53.7 cm)
(see
*
NOTE
)
A
A
B
40" (101.6 cm)
(see *
NOTE
)
A
It is recommended that
sink water and drain
line connections be
located on this side of
cabinet.
It is recommended
that dishwasher
water and drain line
connections be
located on this side
of cabinet.
C
21-1/8"
(53.7 cm)
(see *
NOTE
)
backsplash
CRITICAL
RADIUS
B
radius: 1" (2.5 cm) – the
right back corner must
be cut to this radius
GFCI reset
buttons
25" (63.5 cm)
deep countertop
Countertop
must be level.
SIDE
FRONT
40-1/2" (102.9 cm)
7/16" (1.1 cm) min.
flat surface
required
