Proper installation is your
responsibility:
• Contact a qualified installer.
• Installation must be performed by a
qualified service technician. The
dishwasher must be installed to all
electrical and plumbing national and
local codes and ordinances.
• Install the dishwasher as specified in
these instructions.
• Have everything you need to
properly install dishwasher.
Protect dishwasher and water lines
leading to dishwasher against
freezing. Damage from freezing is not
covered by the warranty.
The dishwasher is shipped ready for
installation of a one-hole faucet. If a
two-, three- or four-hole faucet is to
be installed, the holes must be added
by a qualified plumber according to
the faucet manufacturer's
specifications.
If hot water accessory tank Part No.
4396282 will be used, the tank must
be installed first. It may be difficult to
install the drain line to the T&P valve
on the hot water accessory tank, if it is
not installed first.
2
Before you start...
IMPORTANT:
Observe all governing
codes and ordinances.
Parts supplied:
• undercounter clamp brackets
(adjustable for countertops 3/4"
[1.9 cm] to 1-1/2" [3.8 cm] thick)
• cutting board
Assemble the required tools and
parts before starting installation.
Read and follow the safety
instructions provided with any tools
listed here.
Additional tools may be required to cut
countertop and install drain lines.
• utility knife
• 5/8" open-end wrench (for water fill line
connection)
• 7/16" deep well socket (for undercounter
clamp brackets)
• Copper tubing with compression fitting
for water fill line (3/8" recommended).
Length needed is determined by specific
installation requirements.
• Copper tubing with compression fittings
for faucet connection. Length and
diameter needed are determined by
specific faucet installation requirements.
• small tubing cutter
• tape measure
• flat bladed screwdriver
• faucet
• 2, 1-1/2" drain P traps
• 3-1/2" sink strainer
• plumber's putty
• sink strainer locknut wrench
• 10" adjustable wrench that opens to
1-1/8" (2.9 cm) (for 90° elbow)
• 90° elbow with 3/8" N.P.T. external
threads on one end. (The other end
must fit your water supply line.)
• Teflon
®
tape or pipe joint compound
• 1 cartridge silicone caulk and caulk gun
If using direct wiring:
• 1/4" hex nut driver
• 2 twist-on connectors of proper size to
connect house wiring to 16-gauge
dishwasher wiring.
• CSA-certified, U.L.- or C-U.L.listed
conduit connector to fit
7/8" (2.2 cm) hole
Tools and
materials needed:
This dishwasher is manufactured for
inside use only.
This is the safety alert
symbol.
This symbol alerts you to
potential hazards that can kill or hurt
you and others.
All safety messages will follow the
safety alert symbol and either the word
“DANGER” or “WARNING.” These
words mean:
You can be killed or seriously injured
if you don’t follow instructions.
DANGER
WARNING
Your safety and the safety of
others are very important.
We have provided many important
safety messages in this manual and on
your appliance. Always read and obey
all safety messages.
All safety messages will tell you what
the potential hazard is, tell you how to
reduce the chance of injury, and tell
you what can happen if the instructions
are not followed.
You can be killed or seriously injured
if you don’t immediately follow
instructions.
