KisanKraft
TM
BATTERY SPRAYER
KK-BBS-212/218/315/318
: www.kisankraft.com
: +91.80. 22178200
Page 12 of 32
Please untie the belt and back mat to disclose the battery completely. There are two plugs on
the plate, one is connected to electric power, usually there is a plug connected to an electric
pump to supply power, and the other jack is used to connect with the plug of the charger.
When charging, you only insert the output of the charger to the jack and then connect the input
with 220V alternating current. The signal light on the charger is red during normal charging. It
will change to green when it is fully charged.
The conditions for using the charger:
Standard Voltage
AC100V
～
240V
Input Frequency
50/60Hz
Using Temperature
＋
10
℃
～＋
30
℃
Storing Temperature
－
10
℃
～＋
40
℃
Using Place
Only inside
The time of charging for the new machine or a machine stored
for a long time must be 24 hours.
Don’t let the switch in the place of “
一
”
while charging.
Please pull out the wire of the charger from the jack after the charging is completed.
An Improper battery wire connection will burn the battery and charger. The red wire
should be connected with the red end of the battery.
Don’t charge in a wet room or with wet hands,
as it may cause an electric shock.
Please use the special charger for this machine in order to avoid fire. In addition, it is
prohibited to charge any other electrical machines with the special charger of this
machine or as a power source.
Please pull out the wire of the battery from the socket once the charging is
completed.
Don’t let this machine
exposed to the sun, high temperature conditions and the
things radiating heat, which may lead to ageing of the battery, battery leakages,
radiate heat, split and even fires.
If you find the charger abnormal, pull out from the plug immediately in order to avoid
electric shock, radiating heat and causing fires.
Don’t adopt generator as the electrica
l source of charging, which may destroy the
charger. Don’t
pull the wire off the charger forcibly.
Please clean the electrical pick off of the battery with dry cloth. Bad connection will
cut the power supply or may result in charge failure.
