KisanKraft
TM
POST HOLE DIGGER
EQ9800
: www.kisankraft.com
: +91.80. 22178200
Page 6of 20
OPERATION
CAUTION:
Do not alter/modify the engine or auger
:
Never alter or modify the engine from the factory. Serious injury or death may
occur if the engine is modified or altered.
Always wear hearing protection while operation the engine.
Please do not start your earth auger until you have read the previous section of
this manual. If you have read these, follow the steps below to start your earth
auger.
Never store engine with petrol in the tank indoors. Fuel and fuel vapors are highly
flammable.
Never mix fuel and oil directly in the engine petrol tank. Use only approved non-
metal, portable fuel containers
An adult must always handle and fill the engine with fuel.
Always handle fuel in a well-ventilated area, outdoors, away from flames or
sparks.
Filling Fuel Tank:
1. Shut-off the engine and allow it to cool completely before refilling the fuel tank.
2. Move to a well-ventilated area, outdoors, away from flames and sparks, before
refilling.
3. Clean debris from the area around the fuel cap.
4. Loosen fuel cap slowly. Place the cap on a clean, dry surface.
5. Carefully add fuel without spilling.
6. Do not fill the fuel tank completely full, allow space for the fuel to expand.
7. Immediately replace fuel cap and tighten. Wipe off spilled fuel and allow it to dry
before starting the engine.
NORMAL OPERATION
1. The clutch will transfer maximum power only after two hours of normal operation.
During this break-in period clutch slippage may occur. The clutch should be kept
free of oil or other moisture for efficient operation.
2. Drill holes without placing excessive body weight on the unit. The auger operates
most efficiently with a shaving action caused by the weight of the unit itself.
3. Never run an engine indoors. Exhaust fumes are deadly.
4. Do not use an earth auger in the ice.
5. To attach auger to the power head, align holes at top of auger shaft with the
output shaft hole. Insert 3/8-16 x 1-
1/2” bolt and secure bolt with provided 3/8” bi
-
way lock nut using a wrench
NOTE: The ends of the bolt should be even with the auger collar. Bolt head and thread
end should never go beyond earth collar
Using the Screw Type Manual Venting Fuel Cap:
1. Your power earth auger is equipped with a screw type manual venting fuel cap.
