9
INSTALLATION
INSTALLATION
■
■
Install the battery wand cover with the slot aligned to the socket in the battery wand.
Proceed to”Testing the Blind” on page 10.
If You Have an 18V DC Power Supply...
Connect the Power Supply
■
■
Plug the power cable from the blind into the extension cable.
■
■
Plug the other end of the extension cable into the 18V DC Power Supply.
■
■
Plug the 18V DC Power Supply into a standard outlet.
■
■
Secure the extension cable using wire retainers (not supplied). If hiding the cable
behind the blind, make sure it does not impede the operation of the blind.
■
■
Space the wire retainers approximately 15" apart along the power supply cable, as
shown.
WARNING:
Keep cables and small parts out of the reach of children. They can
wrap cables around their necks and
STRANGLE.
They can also put small parts
in their mouths and
CHOKE.
WARNING:
Electric shock and/or a fire hazard may occur, if not properly
installed.
Proceed to “Testing the Blind” on page 10.
If You Have an 18V DC Power Supply with Daisy-Chain Connections...
The daisy-chain feature allows up to three Tilt Automation blinds to be powered by a single 18V DC Power Supply. However, each
blind has its own transceiver and can operate independently. The daisy-chain feature is only available with the 18V DC Power
Supply option.
■
■
Route the power cables from each blind through the connector, using an extension cable, if necessary.
■
■
Plug an extension cable into the connector and the 18V DC Power Supply. A two-blind configuration is shown below.
■
■
An additional connector and two additional extension cables are used for three blinds.
Battery Wand Cover
Extension
Cable
Power Cable
from Blind
Power Cable
from Blind
Extension
Cable
18V
DC
Power
Supply
15"
Maximum
Wire Retainers
Power Cable
from Blind
Extension
Cable
Connector
